User's Manual
Table Of Contents
- SECTION 6 Installing Unison Accel
- 6.1 Installation Requirements
- 6.2 Safety Precautions
- 6.3 Preparing for System Installation
- 6.4 Unison Accel Installation Procedures
- 6.5 Interfacing an Accel Hub to a Base Station or a Roof-top Antenna
- 6.6 Connecting Contact Alarms to an Accel System
- 6.7 Alarm Monitoring Connectivity Options
- SECTION 7 Replacing Unison Accel Components in an Operational System
- SECTION 8 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B InterReach Unison Accel Property Sheet
- APPENDIX C Compliance
- APPENDIX D Release Notes
PN 9000-10 InterReach Unison Accel Installation, Operation, and Reference Manual D-1
620021-0 Rev. A
APPENDIX D Release Notes
D.1 Unison Accel Release 5
This document is for the Unison Accel products listed in the following table.
Table D-1 Unison Accel Release 5 Line-up
Unison Accel
Component
Part
Number EPN*
Hardware
Revision**
Firmware (FW) or
Software (SW)
Release*
Accel Hub UNS-ACCEL-1 740510-2 C 010559 (FW)
RAU:
PCS UNS-PCS-2 740552-2 C 01053C (FW)
DCS UNS-DCS-1 740553-1 D 01053C (FW)
GSM UNS-GSM-1 740554-1 E 01052B (FW)
Cellular UNS-CELL-1 740550-1 B 01052B (FW)
iDEN UNS-IDEN-1 740551-0 A 01052B (FW)
UMTS UNS-UMTS-1 740560-1 B 01052B (FW)
AdminManager SW-ADM-V2 750001-0 N/A v2.0 (SW)
* Use the Get Unit Info command in the AdminManager’s Configuration & Maintenance Panel to
verify the EPN and Firmware/Software Version of the component
** The hardware revision number is on a label on the back panel of the component