User's Manual
Table Of Contents
- SECTION 6 Installing Unison Accel
- 6.1 Installation Requirements
- 6.2 Safety Precautions
- 6.3 Preparing for System Installation
- 6.4 Unison Accel Installation Procedures
- 6.5 Interfacing an Accel Hub to a Base Station or a Roof-top Antenna
- 6.6 Connecting Contact Alarms to an Accel System
- 6.7 Alarm Monitoring Connectivity Options
- SECTION 7 Replacing Unison Accel Components in an Operational System
- SECTION 8 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B InterReach Unison Accel Property Sheet
- APPENDIX C Compliance
- APPENDIX D Release Notes
PN 9000-10 InterReach Unison Accel Installation, Operation, and Reference Manual B-1
620021-0 Rev. A
APPENDIX B InterReach Unison Accel
Property Sheet
Use the InterReach Unison Accel Property Sheet, which is provided on the following
page, to document a system configuration. The completed form can be used for future
reference when the system is being maintained or components are added or
exchanged. An example of a completed form is shown below.
InterReach
Unison Accel Property Sheet
Installer:
J. Smith
Date:
10/10/02
Accel Hub Serial Number:
L010BMH1
System Label: System Gain: Alarm Sense: System Band:
DCS 2
AB UL: DL:
Yes
No
Normally-Closed
Normally-Open
Unit
HUB - RAU
RAU Attenuation?
Yes/No
RAU
Serial No. RAU Installation Location
AB-1-n — L010BEH9 2nd floor Telecom closet
AB-1 (RAU 1) no L010BRU1 Hallway, outside Boardroom
AB-2 (RAU 2) no L120BRU1 Hallway, outside #230
AB-3 (RAU 3) yes L007BRU1 Hallway, atrium north side
AB-4 (RAU 4) no L111BRU6 Hallway, outside #207
1-5 (RAU 5)
1-6 (RAU 6)
1-7 (RAU 7)
1-8 (RAU 8)
2-n —
2-1 (RAU 1)
2-2 (RAU 2)
2-3 (RAU 3)
2-4 (RAU 4)
2-5 (RAU 5)
2-6 (RAU 6)
1-2-7 (RAU 7)
1-2-8 (RAU 8)
1-3-n (EH 3) —
1-3-1 (RAU 1)
1-3-2 (RAU 2)
1-3-3 (RAU 3)
1-3-4 (RAU 4)
1-3-5 (RAU 5)
1-3-6 (RAU 6)
1-3-7 (RAU 7)
1-3-8 (RAU 8)
1-4-n (EH 4) —
1-4-1 (RAU 1)
1-4-2 (RAU 2)
1
-
4
-
3(RAU3)