User's Manual
Table Of Contents
- SECTION 6 Installing Unison Accel
- 6.1 Installation Requirements
- 6.2 Safety Precautions
- 6.3 Preparing for System Installation
- 6.4 Unison Accel Installation Procedures
- 6.5 Interfacing an Accel Hub to a Base Station or a Roof-top Antenna
- 6.6 Connecting Contact Alarms to an Accel System
- 6.7 Alarm Monitoring Connectivity Options
- SECTION 7 Replacing Unison Accel Components in an Operational System
- SECTION 8 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B InterReach Unison Accel Property Sheet
- APPENDIX C Compliance
- APPENDIX D Release Notes
8-12 InterReach Unison Accel Installation, Operation, and Reference Manual PN 9000-10
620021-0 Rev. A
Table 8-8 Troubleshooting Accel Hub Status LEDs During Normal Operation
During
Normal
Operation
Accel Hub
Status
LEDs State Action Impact
At Any
Time
STATUS
Red Use AdminManager to determine the
exact cause of the fault.
Power cycle one time. If fault
remains, replace the Hub.
Internal Hub fault.
Use AdminManager to check if the
Hub is commanded Out-of-Service
(every Hub
PORT LED will be red
as well).
A power cycle will not clear a com-
manded Out-of-Serivce, you must
use AdminManager to clear this
state.
Main Hub and all downstream units are
off-line.
STATUS
Alternating
Red/Green
Reduce input signal power; reduce
system gain.
Signal compression.