User's Manual

8-8 InterReach Unison Accel Installation, Operation, and Reference Manual PN 9000-10
620021-0 Rev. A
8.3.1.3 Status Messages
Status messages alert you to conditions that may impact system performance. Status
messages are displayed in the Messages pane in blue lettering.
NOTE: The icons displayed in the system status tree assume that there are
no other faults, warnings, or status present.
Accel Hub Status Messages
Table 8-5 Accel Hub Status Messages
Message Icon Action Impact
Commanded out of ser-
vice
Command unit into service using Admin-
Manager.
System is off-line.
Unable to perform sys-
tem test on power up
Check Hubs and RAUs for faults and
warnings.
Degraded system performance.
RAU reports a warning
status
Check RAUs for warnings. Degraded system performance.
Unable to perform sys-
tem end-to-end test
Replace Hub when possible. Degraded system performance.
Fann failure Check the Hub fans for rotation, air flow
blockage, dust
Use AdminManager to check Hub status.
If fans are not operating, replace the Hub.
Temperature may rise to fault level result-
ing in the Hub and connected RAUs being
off-line.
Cat-5/6 cable is longer
than recommended maxi-
mum
Check that the Cat-5/6 cable does not
exceed the recommended maximum
length.
Degraded system performance.
Commanded Fault Lock-
out
Use AdminManager to check Hub faults
and replace Hub as required.
Perform system test.
Connected RAUs are off-line.