User's Manual
Table Of Contents
- SECTION 6 Installing Unison Accel
- 6.1 Installation Requirements
- 6.2 Safety Precautions
- 6.3 Preparing for System Installation
- 6.4 Unison Accel Installation Procedures
- 6.5 Interfacing an Accel Hub to a Base Station or a Roof-top Antenna
- 6.6 Connecting Contact Alarms to an Accel System
- 6.7 Alarm Monitoring Connectivity Options
- SECTION 7 Replacing Unison Accel Components in an Operational System
- SECTION 8 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B InterReach Unison Accel Property Sheet
- APPENDIX C Compliance
- APPENDIX D Release Notes
6-32 InterReach Unison Accel Installation, Operation, and Reference Manual PN 9000-10
620021-0 Rev. A
Using a Base Station and AdminManager to Monitor Unison Accel
In order to take full advantage of Unison Accel’s OA&M capabilities you can use
LGC Wireless’ AdminManager software in addition to a BTS to monitor the system,
as shown in Figure 6-9.
Figure 6-9 Using a BTS and AdminManager to Monitor Unison Accel
Modem
Straight-through modem cable connected
to Accel Hub’s front panel serial port
PSTN
Modem
PC running
AdminManager
Software
BTS
Interface
Cable
Alarm
Sense
Alarm
Source
Alarm
Source
5-port Alarm Daisy-Chain Cable
Unison Accel Hub