User's Manual
Table Of Contents
- SECTION 1 General Information
- SECTION 2 InterReach Unison System Description
- SECTION 3 Unison Main Hub
- SECTION 4 Unison Expansion Hub
- SECTION 5 Unison Remote Access Unit
- SECTION 6 Designing a Unison Solution
- SECTION 7 Installing Unison
- 7.1 Installation Requirements
- 7.2 Safety Precautions
- 7.3 Preparing for System Installation
- 7.4 Unison Component Installation Procedures
- 7.5 Splicing Fiber Optic Cable
- 7.6 Interfacing a Main Hub to a Base Station or a Roof-top Antenna
- 7.7 Connecting Contact Alarms to a Unison System
- 7.8 Alarm Monitoring Connectivity Options
- SECTION 8 Replacing Unison Components
- SECTION 9 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B Compliance
- APPENDIX C Changes and New Capabilities
- APPENDIX D Glossary
New in Rev. G of Manual
C-2 InterReach Unison Installation, Operation, and Reference Manual
CONFIDENTIAL D-620003-0-20 Rev J
C.3 New in Rev. G of Manual
• Ability to filter warnings and status messages
• Reclassification of some faults to warnings and some warnings to status messages.
Faults are service impacting. Warnings are possible service impacting. Status mes-
sages are internal states that could impact service but not at the current time.
C.4 New in Rev. F of Manual
• Added additional reference to Japan Specification Document
C.5 New in Rev. E of Manual
• Added reference to Japan Specification Document
C.6 New in Rev. D of Manual
• Supports 35 MHz PCS RAU
• Refer to “Unison Release 5.1” Field Note (FN03-007, formerly FN-024)
C.7 New in Rev. C of Manual
• Power per Carrier tables
• Removed DCS3
• EGSM is a subset of GSM
• Unison Cat-5 Extender added
• Dual-band Diplexer added