User's Manual

ADCP-75-348 • Issue 1 • 04/2008

Page 10

6.1.1 Tools and Materials

The following tools are required to complete the procedures in this section:

• Box cutter

• Pencil or scribe

• Medium size flat-bladed screwdriver

• Phillips screwdriver (#2)

•Pliers

• Wire cutters

• Wire stripper

• Tool kit for attaching QMA-Type male connectors to coaxial cable

• Multimeter

•Optical power meter

The following materials are required to complete the procedures in this section:

• #18 AWG (1.0 mm) insulated stranded copper wire (for chassis grounding wire)

• #18 AWG (1.0 mm) red and black insulated copper wire (for DC power wires)

• Category 3 or 5 cable (for external alarm system wires)

• Category 5 cable with RJ45 connectors for the Network and Craft port

• #6 ring terminal (1) for #18 wire (for chassis ground wire connection)

• #6 fork terminals (2) for #18 wire (for DC power wiring connection)

• Single-mode patch cord(s) with LC connectors (1 – 8 depending on the application)

• High performance, flexible, low-loss 50-ohm coaxial cable

• QMA-type male connectors

• Wire ties

6.2 Unpacking and Inspection

This section provides instructions for opening the shipping boxes, verifying that all parts have

been received, and verifying that no shipping damage has occurred. Use the following

procedure to unpack and inspect the HU and any accessories:

Unpack and inspect the various components as follows:

1. Inspect the exterior of the shipping container(s) for evidence of rough handling that may

have damaged the components in the container.

2. Unpack each container while carefully checking the contents for damage and verify with

the packing slip.

3. If damage is found or parts are missing, file a claim with the commercial carrier and notify

ADC Customer Service. Save the damaged cartons for inspection by the carrier.

4. Refer to Section 8 if you need to contact ADC.

5. Save all shipping containers for use if the equipment requires shipment at a future date.