User's Manual

ADCP-75-348 • Issue 1 • 04/2008
Page 6
© 2008, ADC Telecommunications, Inc.
Figure 4. Host Unit User Interface
Table 2. Host Unit User Interface
REF
NO
USER INTERFACE
DESIGNATION
DEVICE
FUNCTIONAL DESCRIPTION
SeRF CARD
1 SeRF Card LEDs
ALARM GREEN
RED
No alarms
Alarms present
SYNTH GREEN
RED
Locked
Unlocked
SW FLT GREEN
RED
Software operating OK
Software fault present
PWR GREEN
OFF
Power OK and operating properly
No power present
2 PORT 1 or FWD LC connector
(single-mode)
Output connection point for the forward path
optical fiber.
3 PORT 2 or REV LC connector
(single-mode)
Input connection point for the reverse path pri-
mary optical fiber.
4 PORT 3 –8 LC connector
(single-mode)
Input/output connection points for the remaining
optical fibers.
5 NETWORK RJ-45 jack (female) Connection point for the NETWORK interface
input cable.
6 CRAFT RJ-45 jack (female) Connection point for the CRAFT interface input
cable.
(6) CRAFT
INTERFACE
(5) NETWORK
INTERFACE
(4) OPTICAL PORT
CONNECTORS 3 - 8
(2) PORT 1
FWD
CONNECTOR
(3) PORT 2
REV
CONNECTOR
(1) SeRF CARD
ALARM LEDS
(10) SYSTEM CARD
POWER LED
INDICATOR
(8) DC POWER
ON/OFF SWITCH
(13) REF LED
INDICATORS
(14 & 15)
REF OUT
AND IN JACKS
(11) HOST
ALARM
OUTPUTS
(9) POWER
CONNECTOR
(12) REMOTE
ALARM
OUTPUTS
(7) POWER
LED INDICATOR
(18) REV RF
OUT JACK
(17) DART STATUS
LED INDICATOR
(16) DART POWER
LED INDICATOR
(19) FWD RF
IN JACK
22382-B