Installation Manual

Install the RAUs and Antennas
Page 12 InterReach Spectrum Remote Access Unit Installation Guide
© 2012 TE Connectivity Ltd TECP-77-222 • Issue 1 • August 2012
3 Connectapassivemulti‐bandantennatotheNconnectoroneachRAUusingcoaxialcable
withtheleastamountoflosspossible.(See“AppendixC:OmniAntenna”onpage25for
informationontheOmniAntennaports.)
Omni Antenna
False Ceiling
SRAU
N1
REV IF OUT REV SECONDARY PORTS
1 2 3
FWD SECONDARY PORTS
1 2 3
FWD IF IN
LINK STATUS
LINK STATUS
SECONDARY
REV
SECONDARY
FWD
MRAU
N1
Coaxial cable
Coaxial cable
CAUTION! Firmlyhand‐tightentheNconnector.DONOTover‐tightentheconnector.
ConnecttheIFEUtotheMRAU
NOTE: The IFEU should be powered up before starting this procedure; see the InterReach Spectrum
ExpansionModuleGroupInstallationGuide(TECP‐77‐167).
4 FollowtheserulesfortheCATVcableswhenconnectingtheIFEUtotheMRAU:
• T
heFWDandREVcablesshouldbeclosetothesamelength.
• T
heFWDandREVcablesshouldbethesamecabletype(bothRG6orbothRG11).
• Apairo
fCATVcablesconnectseachMRAUtotheIFEU.TheIFEUREVModuleIFINport
andtheIFEUFWDModuleIFOUTportmustmatch.Forexample,ifIFEUREVModuleIF
INPort3isused,useIFEUFWDModuleIFOUTPort3.
• Refer
to“AppendixB:75‐OhmCATVCable”onpage20forinformationonmaximumRG‐6
orRG‐11CATVcablelengths.
5 Te
stthecableterminationforeachCATVcablebeforeinstallingit.
6 ConnectFcon
nectorCATVcablesontheIFEUandMRAU,intheordergivenbelow.
IftheLEDsdonotperformasdescribedin
thisprocedure,referto“MRAULEDs”onpage7.
a C
onnectaCATVcablefromoneoftheIFEUFWDModuleIFOUTconnectors(1‐8)tothe
MRAUFWDIFINconnector.
b Confirm
thattheMRAUFWDIFINLEDisyellow,whichindicatesacorrectphysical
connection.
c C
onnectaCATVcablefromtheIFEUREVModuleIFINconnector(1‐8)totheMRAUREV
IFOUTconnector,makingsurethatyoupairtheportusedtothesameportnumber
selectedinStep6a.
Iftheconnectioniscorrect,theMRAUpowersupandtheMRAUFWDIF
INLEDturns
green.