User's Manual

Install the RAUs and Antennas
InterReach Spectrum Remote Access Unit Installation Guide - Preliminary Update for Issue 3 Page 13
ADCP-77-168 • Issue 3 • May 2012 © 2012 TE Connectivity Ltd.
6 Connect F connector CATV cables on the IFEU and MRAU, in the order given
below.
If the LEDs do not perform as described in this procedure, refer to “MRAU LEDs”
on page 6.
a Connect a
CATV cable from one of the IFEU FWD Module IF OUT connectors
(1 - 8) to the MRAU FWD IF IN connector.
b Confir
m that the MRAU FWD IF IN LED is yellow, which indicates a correct
physical connection.
c Connect a CATV
cable from the IFEU REV Module IF IN connector (1 - 8) to
the MRAU REV IF OUT connector, making sure that you pair the port used
to the same port number selected in Step 6a.
If the connection is correct, the MRAU powers up and the MRAU FWD IF IN
LED turns gre
en.
IFEU
Step 6a
REV IF OUT REV SECONDARY PORTS
1 2 3
FWD SECONDARY PORTS
1 2 3
FWD IF IN
LINK STATUS
To an antenna
MRAU
Step 6b
Step 6c