User's Manual

Table Of Contents

Page 28 FlexWave Spectrum Remote Access Unit Installation Guide

STANDARDS CERTIFICATION

Federal Communications Commission (FCC)

This equipment complies with the applicable sections of Title 47 CFR, Part 22 (800 MHz Cellular), Part 24 (1900 MHz - PCS),

Part 90 (800/900 - SMR), and Part 27 (700 MHz, 2100 MHz - AWS).

Signal Boosters

WARNING. This is NOT a CONSUMER device. It is designated for installation by FCC LICENSEES and QUALIFIED

INSTALLERS. You MUST have an FCC LICENSE or express Consent of an FCC Licensee to operate this device. Unauthorized

use may result in Significant forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.

Part 90 Signal Boosters

The following statement is applicable to the following RAUs that are documented in this installation guide:

SPT-M3-8019-31-HP, SPT-S1-8019-22, SPT-S1-8090-1, SPT-S1-80AWS-1, SPT-S3-8019-22-HP.

WARNING. This is NOT a CONSUMER device. It is designated for installation by FCC LICENSEES and QUALIFIED

INSTALLERS. You MUST have an FCC LICENSE or express Consent of an FCC Licensee to operate this device. You MUST

register Class B signal boosters (as defined in 47 CFR 90.219) online at http://www.fcc.gov/signal-boosters/registration.

Unauthorized use may result in Significant forfeiture penalties, including penalties in excess of $100,000 for each continuing

violation.

Industry Canada (IC)

This equipment complies with the applicable sections of RSS-131- Zone Enhancers for the Land Mobile Service. The term

“IC:” before the radio certification number only signifies that Industry Canada Technical Specifications were met.

The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple

carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated

and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction

and not by an attenuator at the output of the device.

NOTE: The U. S. Federal Communications Commission (FCC) has developed guidelines for evaluation of human exposure

to RF emissions. The guidelines incorporate limits for Maximum Permissible Exposure (MPE) for power density of

transmitter operating at frequencies between 300 kHz and 100 GHz. Limits have been set for portable, mobile, and

fixed equipment. TE Connectivity products fall in the category of fixed equipment; products intended to be

permanently secured and exposures are evaluated for distances greater than 40cm (15.75”). Portable devices fall

into exposures of less than 20cm, where SAR evaluations are used.

Antenna gain is restricted to 1.5 W ERP (2.49 W EIRP) in order to satisfy RF exposure compliance requirements.

If higher than 1.5 W ERP, routine MPE evaluation is needed. The antennas should be installed to provide at

least 40cm from all persons to satisfy MPE requirements of FCC Part 2, 2.1091.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2)

l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102

RF exposure, users can obtain Canadian information on RF exposure and compliance.

Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à

l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.