User's Manual

Install the RAUs and Antennas
Page 14 InterReach Spectrum Remote Access Unit Installation Guide
© 2013 TE Connectivity Ltd TECP-77-222 Issue 2 • 300001759666 Rev B • December 2013
ConnecttheMRAUtoSRAUs
CAUTION! Topreventinterference,donotinstallan850/1900MRAUantennanearan800/900SRAU.The
850MHzbandmustbe20feetawayfromthe800/1900SRAU’spassiveantenna.
7 Useoneofthefollowing6’and20’CATVRG6jumpers,availableforpurchasefromTE
Connectivity,toconnectanMRAUtoSRAUs.
8 TestthecableterminationforeachCATVcablebeforeinstallingit.
9 ConnectFconnectorCATVcablesfromtheMRAUtoanSRAU,intheordergivenbelow.Ifthe
LEDsdonotperformasdescribedinthisprocedure,referto
“SRAULEDs”onpage9.
a ConnectaCATVcablefromanMRAUFWDSECONDARYPORT(1,2,or3)Fconnectorto
theSRAUSECONDARYFWDFconnector.
b ConfirmthattheSRAUSECONDARYFWDLEDisyellow,whichindicatesacorrect
physicalconnection.
c ConnectaCATVcablefromanMRAUREVSECONDARYPORT(1,2,or3)Fconnectorto
theSRAUSECONDARYREVFconnector,matchingthesameportnumberselectedinStep
9a.Thatis,ifinStep9ayouconnectedanFconnectortotheMRAUFWDSECONDARY
PORT1,thepairedCATVcablemustconnecttotheMRAUREVSECONDARYPORT1.
Iftheconnectioniscorrect,theSRAUpowersupandtheSRAUSECONDARYFWDLED
turnsgreen.
NOTE: TorqueappliedtotheFconnectorCATVcablesshouldbe7±5%in‐lbs.
TE Connectivity
Part Number
Description Note
300469-0 6’ RG-6 Cable; F Male to F Male CATV cable that connects the MRAU to SRAUs. Two
cables required per SRAU.
300469-1 20’ RG-6 Cable; F Male to F Male CATV cable that connects the MRAU to SRAUs. Two
cables required per SRAU.