User's Manual

Warning: This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instruction manual, may cause interference to radio
communications. It has been tested and found to comply with limits for a Class B digital device
pursuant to Subpart A of Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference when operated in a residential environment. If interference
to TV and radio reception does occur relocate or reorient the antenna of the affected radio or TV.
This equipment does not exceed Class B limits for radio emission for digital apparatus, set out
in the radio interference regulation of the authorization methods of Industry Canada.
This product conforms to all applicable standards of 21 CFR 1040.
ADCP-75-237 • Issue 1 • 8/2007 • Preface
Page ix
© 2007, ADC Telecommunications, Inc.
Certification: UL/ETL/CSA/CE/NEBS Listed (delete inapplicable items, here and in TOC)
State condition of UL, ETL and/or CSA status. An example: X has been tested and found to
comply with the requirements of UL/CSA 60950.
XXX modules and chassis have been tested and found to comply with all applicable CE
Directives.
XXXX complies with the requirements of GR-63-CORE, Issue 1, October 1995 and GR-1089-
CORE, Issue 2, December 1997 with Revision 1, February 1999 as specified in SR-3580, Issue
1, 1995.
Standards
The following listing is a bibliography of applicable ANSI and Bellcore documents:
ANSI T1.403-1989 Carrier-to-Customer Installation — DS1 Metallic Interface, February 22,
1989.
ANSI T1E1.4/91-002R2 Study of the Feasibility and Advisability of Digital Subscriber Lines
Operating at Rates Substantially in Excess of the Basic Rate.
etc.
etc.
STANDARDS CERTIFICATION
Below is an alternative format for standards certification.
FCC: The Digivance NXD complies with the applicable sections of Title 47 CFR Part 15, 22,
24 and 90.
The Digivance NXD Hub has been tested and found to comply with the limits for a Class A dig-
ital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial envi
-
ronment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to