User's Manual
Table Of Contents
- ABOUT THIS MANUAL
- ADMONISHMENTS
- GENERAL SAFETY PRECAUTIONS
- FCC Compliance Statement
- STANDARDS CERTIFICATION
- LIST OF ACRONYMS AND ABBREVIATIONS
- SECTION 1: OVERVIEW
- SECTION 2: Installation
- SECTION 3: Graphical User Interface
- SECTION 4: GENERAL INFORMATION
ADCP-75-237 • Issue 1 • 8/2007 • Section 3: Graphical User Interface
Page 3-9
© 2007, ADC Telecommunications, Inc.
- Port: Select serial port number from 1 to 16
- BaudRate: Select Baud rate “9600”bps
- Data Type: DataBit: Select “8”bit, Parity: Select “None”, StopBit: Select “1”
- Echo: Select “Off”, “LF”
- Flow: Select “None”
- H/W: Select both.
All options may use default settings except for “Port”. You must select correct port # that the
computer is connected to the equipment with.
After finishing the selection, press “OK” to save and return to the main setting window. If you
press “Cancel”, the selections are not be saved and you are returned to the Port Properties
window. If the selected port is not correct, the program displays “It's not available” on the
screen and requests that you select another port.