User's Manual
Table Of Contents
- ABOUT THIS MANUAL
- ADMONISHMENTS
- GENERAL SAFETY PRECAUTIONS
- FCC Compliance Statement
- STANDARDS CERTIFICATION
- LIST OF ACRONYMS AND ABBREVIATIONS
- SECTION 1: OVERVIEW
- SECTION 2: Installation
- SECTION 3: Graphical User Interface
- SECTION 4: GENERAL INFORMATION
ADCP-75-237 • Issue 1 • 8/2007 • Section 3: Graphical User Interface
Page 3-8
© 2007, ADC Telecommunications, Inc.
2.3 Status Bar
- Status:
Window bottom line Status shows connected/disconnected status and time being
connected. Upper right side check box will also denote Communication status of connected
activity.
- Port: Window bottom line Port shows the connected port number
- Properties: Window bottom line Properties shows the property information.
Note: You must install a USB driver to use the USB port. After installing the driver, the
software recognizes the USB driver as a normal com port.
3 SET COMMUNICATION PORT PROPERTIES
Communication parameters must be set before the computer can communicate with the repeater.
All GUI controls can be used after connecting the repeater system using the following
“Connection” procedure.
1. Open “Setting” -> “Connection”
2. Port Properties window opens.