User's Manual

FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 90 © May 2017 CommScope, Inc.
Install the RF Module(s)
INSTALL THE RF MODULE INTO THE PRISM REMOTE CHASSIS
1 HoldtheRFModulesothattheDARTcard(s)faceawayfromthePRUandtheMountingHookistowardthe
ReceivingflangeonthePRUchassis.
NOTE: Always install RF Modules from the bottom up. Do not skip a bay, as this provides more efficient heat
dissipation.
2 HoldingtheRFModuleata45°angleinrespecttotherearheatsink,restthebottomsurfaceofthemodule
ontheRFModuleshelf,asshowninoneofthefollowinggraphics,andasapplicabletotheRFModule.
• Single-BayRFModule:Figure21onpage90
• HDMRFModule:Figure22onpage91
• Dual-BayRFModule:Figure23onpage92
• LegacyDual-Bay40WRFModule:Figure24onpage93.
Figure 21. Installing a Single-Bay RF Module
Bay C
Bay D
SeRF
Module
Bay A
Bay B
Single-Slot
RF Module
Heat Sink