User's Manual

Install the RF Module(s)
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 89
DUAL-BAY MODULES ONLY—REMOVE THE MODULE BAY SHELF
FORDUAL-BAYRFMODULESONLY.
IfyouareinstallingaDual-BayRFModule,you
mustremoveamodulebayshelffromthePRU
chassistoaccommodatethemodule’ssize.(For
furtherinformation,see
Table16onpage27.)
RemovetheshelfasappropriatefortheRF
Module:
• WheninstallingintheAandBBays,remove
theModuleBBayShelf.
• WheninstallingintheCandDBays,remove
ModuleDBayShelf.
ToremoveaModuleBayShelf:
1 Usea9/64”Allen
™
wrenchtoremovethe
threescrewsthatattachthemoduleshelfto
thePRUchassis,asshowninthegraphicto
theright.
2 Discardorstorethemoduleshelfand
fasteners.
Use 9/64” Allen Wrench to
remove the three module-shelf screws
Remove Module D Shelf for
Dual-Band Dual-Slot RF Modules
Remove Module B Shelf for
Dual-Slot 40W RF Modules