User's Manual

FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 110 © May 2017 CommScope, Inc.
Install the RF Module(s)
POWER ON THE RF MODULE(S) AND THE PRISM REMOTE UNIT
1 Ifnecessary,poweruptheRemoteUnitbyturningitsACorDCpowerswitchtoOn.
2 EnsurethattheexternalStatusLEDonthebottomoftheRemoteUnitgoesoff.(Atsystemstartup,theStatus
LEDisredtoindicatethattheRemoteUnitispoweringupandthattheSeRFprocessordoesnotyetcontrol
theRemoteUnit;theStatusLEDwillremainredfornomorethan4minutes;forfurtherinformationsee
"RemoteUnitStatusLED”onpage10.)
NOTE: The preceding graphic illustrates the Status LED on a Quad-Bay PRU. The Status LED for the Single-Bay,
Dual-Bay, and Tri-Bay PRUs is in the same location and functions the same as the Status LED for the
Quad-Bay PRU.
Boom of an AC-Powered PRU Boom of a DC-Powered PRU
Status LED
NETWORK
POWER
48VDC/XXA
MOD D
TX1/RX1
NETWORK
MOD D
TX1/RX1
POWER
100-240 VAC
50-60 Hz
XX AMPS
WARNING:
HIGH LEAKAGE CURRENT. EARTH
CONNECTION ESSENTIAL BEFORE
CONNECTING SUPPLY
MOD D
TX0/RX0
MOD D
TX0/RX0