User's Manual

Install the RF Module(s)
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 109
c ConnecttheLVDSCablestotheRFModule—theLVDScableslabeledPRIMandDIVshouldalwayseither
beconnectedtoaRFModuleorstrainrelievedtoadjacentcables,asthisprotectsthecableagainst
damagethroughmisplacement.Maintainadequatestrain-reliefdistancesfromtheconnectionpointsto
theRFModule.
i ConnecttheMODNDIVLVDSCabletotheDIVreceptacleoftheRFModulebyinsertingandslidingin
untilfullyseated.FullinsertioncanberecognizedbyanaudibleclickastheLVDSCableConnector
locksintotheRFModuleReceptacle.
ii ConnecttheMODNPRIMLVDSCabletothePRIMconnector,followingthesamestepsasabove.Full
insertioncanberecognizedbyanaudibleclickastheLVDSCableConnectorlocksintotheRFModule
Receptacle.
iii EnsurethetwoLVDScablesarefullyseatedandlatchedintotheirrespectivereceptaclesontheRF
Modulebylightlypullingoutwardontheconnectors.Iffullyseatedandlockedintoposition,thecable
connectorswillnotslidebackout.
d ConnectthePowercabletothePWRreceptacleoftheRFModule.
i EnsurethattheDCpowerswitchthatcorrespondstothebay(s)inwhichtheRFModuleistobe
installedisintheOffposition(see"ChecktheDCPowerSwitchfortheModuleBay”onpage88).
ii InsertthePowercableintothePWRreceptacleofthelowerRFModulebay,andslideitinuntilfully
seated.FullinsertioncanberecognizedbyanaudibleclickasthePowerCableConnectorlocksinto
theRFModuleReceptacle.
i InsertthePowercableintothePWRreceptacleoftheupperRFModulebay,andslideitinuntilfully
seated.FullinsertioncanberecognizedbyanaudibleclickasthePowerCableConnectorlocksinto
theRFModuleReceptacle.IfthePWRreceptacleisnotavailable,constrainthePowercableto
accompanyingcablesusingatiewrapsoitcannotbepinchedorpreventtheRemoteUnitdoorfrom
closing.
ii VerifythatthePowercableisfullyseatedbylightlypullingbackonitwhilemakingsuretonot
depressthereleasetriggersontheendsoftheconnector.Whenfullyinserted,thecableshouldnot
beabletoberemovedfromthereceptacle.
4 Repeatallthestepsin"InstalltheRFModule(s)”onpage84toinstallotherRFModules.