User's Manual

FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 106 © May 2017 CommScope, Inc.
Install the RF Module(s)
Connecting Cables in a Dual-Bay RF Module Installation
1 PositionthecablessothattheyareundertherightedgeoftheRFModule,pointingup.
2 Followtheruleslistedin"UnderstandingRFCableRules”onpage26.
3 ConnecttheRFModulecables,workingfromthebottomconnectorup,asdescribedbelow.
Asyouwork,refertothegraphicthatcorrespondstotheRFModulebeinginstalledintheDual-Bay:fora
Dual-BayRFModule,referto
Figure33onpage107,andforaLegacyDual-Bay40WRFModule,referto
Figure34onpage108.
a ConnecttheMODNTX1/RX1cabletotheN-StyleRFconnectorontheDual-BayRFModule(theRFcables
andconnectorsarereferredtoasMODNTX1/RX1whereNequalsB,C,orD).
i ConstraintheMODNTX1/RX1cableofthelowerRFModulebaytoaccompanyingcablesusingatie
wrapsoitcannotbepinchedorpreventtheRemoteUnitdoorfromclosing.
ii ConnecttheMODNTX1/RX1cabletotheTX1/RX1N-StyleJackoftheupperRFModuleBay.
iii Turnthecouplingnutoftheplugclockwisetothreadontothejackandfinger-tighten.
iv Torquecouplingnutto8±1in-lbstoensurefullconnection.
NOTE: Insufficient torque applied to RF Module connections can result in elevated insertion/return loss and
higher than normal VSWR reported by the system.