User's Manual

Table Of Contents

Install the RF Module(s)

FWPP-504-02 FlexWave

Prism Remote Unit and RF Module Installation Guide

c ConnecttheLVDSCablestotheRFModule—theLVDScableslabeledPRIMandDIVshouldalwayseither

beconnectedtoaRFModuleorstrainrelievedtoadjacentcables,asthisprotectsthecableagainst

damagethroughmisplacement.Maintainadequatestrain-reliefdistancesfromtheconnectionpointsto

theRFModule.

i ConnecttheMODNDIVLVDSCabletotheDIVreceptacleoftheRFModulebyinsertingandslidingin

untilfullyseated.FullinsertioncanberecognizedbyanaudibleclickastheLVDSCableConnector

locksintotheRFModuleReceptacle.

ii ConnecttheMODNPRIMLVDSCabletothePRIMconnector,followingthesamestepsasabove.Full

insertioncanberecognizedbyanaudibleclickastheLVDSCableConnectorlocksintotheRFModule

Receptacle.

iii EnsurethetwoLVDScablesarefullyseatedandlatchedintotheirrespectivereceptaclesontheRF

Modulebylightlypullingoutwardontheconnectors.Iffullyseatedandlockedintoposition,thecable

connectorswillnotslidebackout.

d ConnectthePowercabletothePWRreceptacleoftheRFModule.

i EnsurethattheDCpowerswitchthatcorrespondstothebay(s)inwhichtheRFModuleistobe

installedisintheOffposition(see"ChecktheDCPowerSwitchfortheModuleBay”onpage88).

i InsertthePowercableintothePWRconnector,andslideitinuntilfullyseated.Fullinsertioncanbe

recognizedbyanaudibleclickasthePowerCableConnectorlocksintotheRFModuleReceptacle.

ii VerifythatthePowercableisfullyseatedbylightlypullingbackonitwhilemakingsuretonot

depressthereleasetriggersontheendsoftheconnector.Whenfullyinserted,thecableshouldnot

beabletoberemovedfromthereceptacle.

CAUTION! Maintain adequate strain relief distances from the connection points to the RF Module.

4 Repeatallthestepsin"InstalltheRFModule(s)”onpage84toinstallotherRFModules.