User's Manual
Table Of Contents
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Fan Module Maintenance
- Specifications
- Standards Certification
- DCCS Global Technical Support
- DCCS Technical Training
- Accessing FlexWave User Documentation
FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 98 © May 2017 CommScope, Inc.
Install the RF Module(s)
Connect Latches on Single-Bay and HDM RF Modules
ForSingle-BayandHDMRFModules,securetwolatches,asshowninFigure28.
Figure 28. Latches on Single-Bay and HDM RF Modules
Two latches on
Single-Slot
RF Modules
Two latches on
HDM RF Modules