User's Manual

Overview of RF Modules for Prism Remote Units
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 21
LEDS on Narrowband HDM RF Modules
Ref # LED LED Color Description
1DPM Power
Green HDM RF Module is powered on.
Red Problem with the HDM RF Module power.
2 FPGA Status Blinking Green Blinks as heartbeat of the HDM RF Module.
3
LVDS 0 Status
Green Primary LVDS Dynamic Phase Alignment (DPA) connector is operating as expected.*
Red Primary LVDS DPA connector is not operating as expected.
4
LVDS 1 Status
Green Primary LVDS Dynamic Phase Alignment (DPA) connector is operating as expected.*
Red Primary LVDS DPA connector is not operating as expected.
5 DSP/GC Status — Not used.
6 FPGA Load Status
Red FPGA is in startup mode.
Off FPGA load is complete.
7TXA Status
Green All synthesizers are locked.
Blinking Green One or more synthesizer is unlocked.
Red Overflow on RX.
8 RXA Status
Green All synthesizers are locked.
Blinking Green One or more synthesizer is unlocked.
Red Overflow on RX.
9 TMA A Status — Not used.
10 TXB Status
Green All synthesizers are locked.
Blinking Green One or more synthesizer is unlocked.
Red Overflow on RX.
11 RXB Status
Green All synthesizers are locked.
Blinking Green One or more synthesizer is unlocked.
Red Overflow on RX.
12 TMA A Status — Not used.
1 LED is only applicable to the Primary connector; it is not tied to the status of the Secondary DPA connector.
1
2
3
4
5
6
7
10
11
12
8
9