User's Manual

ManualsBrandsADC Telecommunications ManualsElectronicsFWP-Z4MT000MOD

Table Of Contents

Document Overview
Overview of Prism Remote Units
- Prism Remote Unit Components
- Ports and Connectors
Overview of RF Modules for Prism Remote Units
Configuring the System with RF
- RF Group Assignments for PRU RF Module Bays
- Understanding RF Cable Rules
  - RF Module Cables and Supported Bay Use for Single-Card, Dual-Card, and HDM RF Modules
  - RF Module Cables and Supported Bay Installations for Legacy Dual-Bay 40W RF Modules

Overview of RF Modules for Prism Remote Units

FWPP-504-02 FlexWave

®

Prism Remote Unit and RF Module Installation Guide

© May 2017 CommScope, Inc. Page 17

Legacy Dual-Bay 40W RF Modules

TheLegacyDual-Bay40WRFModule(Figure5)isdesignedforAWSandPCSfrequenciesandissupportedonly

byClassicDARTs.TheLegacyDual-Bay40WRFModulecomprises:

• oneClassicDART

• oneDuplexerthatcomprises

– oneLowNoiseAmplifier(LNA)

– onePowerDetector(PD)

• twoPowerAmplifiers(PAs)

• oneRemoteDARTInterface(RDI)board.

NOTE: This manual describes how to install the PCS 1900 and AWS 2100 Non-Diversity RF Modules.

Figure 4. Legacy Dual-Bay 40W RF Module