User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 79
Option 2: Connect the DC Power Wiring
NOTE: All electrical work must comply with local codes and requirements. A locally licensed electrical
contractor is best qualified to perform this work. For additional information, consult with the
CommScope Technical Support for Wireless Products team (see "DCCSGlobalTechnicalSupport”on
page124).
1 Usetheinformationin"DeterminetheCircuitBreakerorFuseforthePRU”onpage72toensurethatthe
correctcircuitbreakerorfuserequiredforthisinstallationisinstalledinth
eDCPowerSourceDistribution
Panel.
2 Ob
tainaDCpowercablethatmeetsthefollowingrequirements:
• The
DCpowercablecanbe8AWGor6AWG,3-or4-conductorpowercableratedforoutdooruse.
• T
hewirecolorsmustbegreen,red,andblack.
• The
cablediametermustbe.71to.98inches.
• I
fa4-conductorpowercableisused,theextraconductorcanbesnippedoffbeforeinstallation.
• Ifusing
6AWGwire,theinstallermustprovideanduse#10studsize,6AWGringterminals.
3 Remov
ethecable-glandplugfromthebottomofthePRUchassis:
Cable-gland plug