User's Manual

Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 77
5 InstallanyACpowersupplywiresthatmayberequiredbetweentheACjunctionboxandtheACcircuit
breakerbox.
NOTE: It is recommended that an AC outlet be in
stalled near the PRU for powering tools and test equipment.
This outlet must include a GFCI device for protection.
NOTE: An appropriate disconnect device, as well as branch circuit protection, must be provided as part of the
installation.
6 ConnecttheACpowercable
wirestotheACpowersupply
wire
s.Refertothegraphicto
therighttoidentifythecolor
codeandwiredesignations;
usethealignmentkeyto
ensurethatthecable
correctlyalignswiththe
connector.Ifthecableisnot
alignedcorrectlywiththe
connector,connectorpins
maybedamaged.
7 At
theACbox,connecttheAC
powersupplyloadwirestoa
circuitbreakerorfuse.
CAUTION! For proper and safe
equ
ipment operation,
an approved earth ground connection must be provided and maintained.
8 Connectthegroundwiretoanapprovedearthground.
9 Place
thecircuitbreakerintheONpositionandthentesttheconnectorendoftheACpowercableforproper
voltagelevelsandcorrectpolarity.
10 Wh
entestingiscomplete,placethecircuitbreakerintheOFFposition.
M16 Connector
3 Black1 White
Female-End View
2 Green
Alignment key