User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 69
2 RemovethedustcapfromthefibercableBX5connector(FIBER1).
3 Cleanallfiberco
nnectorsfollowingindustryapprovedprocedure.
4 Align
theplugendoftheBX5cableconnectorwiththeBX5portreceptacleandtheninsertthecablepluginto
theportreceptacleasshownbelow,andthenslidethestrainreliefbootovertheconnector.
Fiber 1 is a
ProAx connector
that comprises
4 BX5 connectors
Shaded area is the
Alignment Key for
the BX5 cable
connector
BX5 Cable connector