User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 67
Option C: ProAx Connector (Legacy AC-Powered PRUs)
NOTE: Use the following procedure to install the fiber cables using a legacy ProAx Connector.
• If the PRU that you are installing has a Hardened Multi-Fiber Optic
Connector, follow the procedure
in "Option A: Hardened Multi-Fiber Optic Connector” on page 56
• If the PRU that you are installing has a Fiber Pass-Through Conn
ector, follow the procedure in
"Option B: Fiber Pass-Through Connector” on page 62.
NOTE: The ProAx Connector will become obsolete effective 31 May 2013, and will not be used in PRUs
manufactured after 31
May 2013.
NOTE: DC-powered PRUs do not have a ProAx connector option.
APRUwiththeProAxConnectorconfigurationrequiresthepurcha
seofaProAxcableassemblyforthePrismto
interfacewiththeOSPfiber.ThefibercableconnectorisaBX.5four-portfiberconnector,asshowninthe
followingpicture: