User's Manual

Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 61
2 Rotatethecouplingnutofthe
Multi-FiberOpticcable
counter-cl
ockwisetoremoveits
dust-covercap,asshowninthe
graphictotheright.
3 Clean
theMulti-FiberOpticcable
connectorusingindustryapproved
cleaningprocedures.
4 Clean
theFiber1portusingindustryapprovedcleaningprocedure.
5 InserttheMulti-Fiber
OpticcableintotheFIBER
1co
nnector;refertothe
introductorymaterialfor
thissectionfor
informationoncabling
requirements.
a Aligntheplugendof
the
cablewiththekey
asindicatedonthe
overlayfortheFIBER
1connector,asshown
totheright.
b U
sea9/16”wrenchto
rotatethecoupling
nutclockwise;tighten
to2-4in-lbs.
6 RoutetheMulti-Fiber
Opticcablefromthe
underside
ofthePRUto
theOSPbox.
7 Secure
fibercableinplace
followinglocalpractices.
8 Ifneces
sary,complete
Step1throughStep7to
addasecondMulti-Fiber
Optic
cabletotheFIBER2
connector.
9 Continueto"Connectthe
AntennaCable”on
page71.
Coupling nut
Mul-fiber opc cable
AC or DC PRU
(The Fiber 1 and Fiber 2 connectors are in the same
locaon for both the AC- and DC-powered PRUs.)