User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 60 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
UsethefollowingproceduretoinstallthefibercablesusingtheHMFOC.
1 Use
a7/16”wrenchorsockettoremovethedust-covercapfromtheFiber1connector,locatedatthebottom
ofthePRU.Youneedtoturnthecapcounter-clockwiseforseveralturns.
NOTE: Do not remove the dust cover from the Fiber 2 connector until
directed to do so.
CAUTION! To avoid the risk of equipment damage, ensure that the AC/DC Power switch to the Remote
Unit chassis and the DC power switch to all RF Module bays are in their OFF position before
connecting or disconnecting coaxial cables; otherwise equipment damage may occur.
AC or DC PRU
Fiber 1
Fiber 2
(The Fiber 1 and Fiber 2 connectors are in the same
locaon for both the AC- and DC-powered PRUs.)