User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 59
Figure14showsthecablingrequirementsforSingle-andDual-WDMunits.
Figure 14. Multi-Fiber Optic Cabling for Single
- and Dual- WDM Units
1 RX - Orange
1 TX - Blue
Single-WDM HMFOC Units
1 RX - Orange
2 RX - Brown
WDM 1 Connector 1
1 TX - Blue
2 TX - Green
WDM 2 Connector 1
Dual-WDM HMFOC Units