User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 58 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
Figure13illustrateshowtheMulti-FiberOpticCablesusedwithHMFOCconnectorsrunbetweentheFiber1and
Fiber2connectorsandtheSFPs.
Figure 13. Multi-Fibe
r Optic Cabling
Fiber 1 and Fiber 2 Connectors
(boom of PRU)
Fiber-opc cable runs
between the Fiber 1 and Fiber 2
Connectors and the SFPs
Fiber 1 assembly
Fiber 2 assembly
Fiber 1 and Fiber 2 cable
Fiber 1 Connector
(boom of PRU)