User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 57
Table21identifieshowthefibersintheMulti-FiberOpticCablecorrelatetotheSeRFSFPs,whichcomepre-wired
fromthefactory.
NOTE: Each SFP utilizes a single fiber o
ptic pair. Each SFP can support up to 12 timeslots with up to 75 MHz of
bandwidth. Each fiber connector on the PRU contains 4 fiber pairs, supporting the use of 4 SFPs. If
additional SFPs are necessary, use the second fiber connector (FIBER 2).
Table 21. Multi-Fiber Optic Cable Color Codes
Fiber Connector # Color SeRF SFP Connector Fiber Connector # Color SeRF SFP Connector
1Blue1 TX
2Blue5 TX
1Orange1 RX
2Orange5 RX
1 Green 2 TX
2Green6 TX
1Brown2 RX
2Brown6 RX
1Gray3 TX
2Gray7 TX
1White3 RX
2White7 RX
1Red4 TX
2Red8 TX
1 Black 4 RX
2Black8 RX