User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 56 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
CONNECT FIBER CABLE TO THE PRU CHASSIS
TherearethreefiberconnectoroptionsforthePrismRemoteUnit;followthefibercableinstallationprocessthat
isappropriatefortheconfigurationofthePRUthatyouareinstalling:
• "OptionA:HardenedMulti-FiberOpticConnector”onpage56
• "OptionB:FiberPass-Thr
oughConnector”onpage62
• "OptionC:ProAxConnector(LegacyA
C-PoweredPRUs)”onpage67.
Option A: Hardened Multi-Fiber Optic Connector
NOTE: Use the following procedure to install the fiber cables using a Hardened Multi-Fiber Optic Connector. If
the PRU that you are installing has a Fiber Pass-Through Connector, follow the procedure in "Option B:
Fiber Pass-Through Connector” on page 62. If the PRU that you are installing has a legacy ProAx
Connector, follow the procedure in "Option C: ProAx Connector (Legacy AC-Powered PRUs)” on page 67.
PRUsnowhaveaHardenedMulti-FiberOpticConnecto
r(HMFOC),asshowninthepicturebelow.
AllPRUswiththeHMFOCconfigurationrequirethepurchaseofaM
ulti-FiberOpticCable,suchastheoneshown
below,whichallowsthePRUtointerfacewiththeOSPfiber.