User's Manual

Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 55
2 RoutethenetworkcablefromthenetworkconnectiontotheundersideofthePRU.
3 Align
theplugendoftheRJ-45cableconnectorwiththeRJ-45portreceptacleandtheninsertthecableplug
intotheportreceptacle.
4 Slidetheconnecto
rnutuptotheportuntilitengagestheconnectorlockingmechanism.
5 Tighten
theconnectornutinaclockwisedirection(ifnecessary,useawrenchtogriptheconnectornut)until
itsnapspasttheindentedpositionandlocksintoplace.Itmaybenecessarytoapply30to50in-lbs(3.4to
5.6Nm)oftorquetotheconnectornuttoturnitpasttheindentedposition.
DC-Powered PRU
AC-Powered PRU