User's Manual

Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 53
2 Locatea#6AWG(4mm)coppergroundingwirelongenoughtoreachanapprovedearthground.
3 Use
asocketwrenchwitha3/8-inchdeepsockettoremovethetwo10-32KepsNutsfromtheDual-Ground
connectoronthebottomofthePRU.
4 Secure
theringterminalendofthegroundingwiretothegroundstudsontheunitusingthetwo10-32Keps
NutsremovedinStep3,andthentorquethenutsto18in-lbs±1in-lb.
5 Routethefreeendofthegrounding
wiretoanapprovedearthgroundsource.
6 Cut
thegroundwiretolengthandconnectittotheearthgroundsourceasspecifiedbylocalcodeorpractice.
To Earth Ground
Ground wire
10-32
Keps Nuts
AC-Powered PRU
Dual-Ground
connector
To Earth Ground
Ground wire
10-32
Keps Nuts
DC-Powered PRU
Dual-Ground
connector