User's Manual
Table Of Contents
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Determine the Circuit Breaker or Fuse for the PRU
- Connect the Power Wiring
- (Optional) Connect the Prism Remote Unit to a UPS
FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 52 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
GROUND THE PRU CHASSIS
CAUTION! Avoid sharp bends in the ground wire.
CAUTION! For proper and safe equipment operation, use a #6 copper wire terminated with the provided ring
terminal to link the PRU to an earth-ground source.
1 Ensuret
hattheAC/DCPowerswitchtothePRUchassisandtheDCpowerswitchtoallRFModulebaysare
intheirOFFposition.
DC Power switch for Bay A
DC Power switch for Bay B
DC Power switch for Bay C
DC Power switch for Bay D
AC/DC Power switch
for PRU chassis