User's Manual

Install the Prism Remote Unit
FWPP-504-02 FlexWave
®
Prism Remote Unit and RF Module Installation Guide
© May 2017 CommScope, Inc. Page 51
Installing a PRU on the Mounting Bracket
ThebasicproceduretohangaPRUonaMountingBracketisthesame.Theillustrationsinthisprocedure,
however,showapole-mountinstallation.
1 Referto"MountingCautions”onpage42beforebeginningthisprocess.
2 Use
theD-RingsonthetopofthePRUtohoistthePRUintopositionforattachmenttotheMountingBracket.
CAUTION! To avoid damage to the PRU and to avoid personal injury,
use appropriate lifting equipment.
3 M
atethemountinghooksonthebackofthePRUwiththe8horizontalhanging-bracketpinsontheMounting
Bracketasshownbelow.
4 Lower
thePRUuntiltheMountingCaponthetopofthePRUissnugagainstthetopoftheMountingBracket.
5 Use
theflat-bladescrewdrivertosecurethetwocaptivefastenersonthebottomofthePRUtotheMounting
Bracket.
Mounng
hooks (8)
Hanging-Bracket
Pins (8)
D-Rings
Mounng Cap