User's Manual

FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 50 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
7 Refertoanchormanufacturer'stechnicaldatatoensureproperdrilldiametertobeused,andthendrillholes
inthewallatthelocationsmarkedinStep6.
8 Refe
rtothefollowingfigureanddothefollowing:
a Settheanchorsint
hewall.
b Locate
thetwo1/2x1-1/2-inchmountingboltsandplacea1/2-inchlockwasherand1/2-inchflat
washeroneachbolt.
c Pl
acetheMountingBracketoverthetwoanchors.Threada1/2x1-1/2-inchmountingbolt(with
installedwashers)intoeachoneoftheanchors.Tightenboltsuntilsecure.
9 H
angthePRUfromtheMountingBracketasshownin"InstallingaPRUontheMountingBracket”onpage51.
1/2-inch flat washer
Masonry Wall
1/2-inch Concrete
anchors
1/2 x 1-1/2-inch Hex bolt
1/2-inch Lock washer
Mounng bracket
1/2 x 1-1/2-inch Hex bolt
1/2-inch flat washer
1/2-inch Lock washer