User's Manual

FlexWave
®
Prism Remote Unit and RF Module Installation Guide FWPP-504-02
Page 44 © May 2017 CommScope, Inc.
Install the Prism Remote Unit
3 Slideabuckleonthebandandsecurebydoublingoverunderbuckle,asshownintheillustrationbelow,or
asinstructedinmanufacturer'sinstructions.
BandsshouldpassthrougheachslotoftheMountingBracket,fro
mtoptobottom,ensuringthebandpasses
overthetopofthepins,asshownbelow,andagainthroughthebuckle.
4 Wrap
thebandaroundpoleoncemore,passingthroughtheslotsintheMountingBracketandoverpins,and
againthroughbuckle.Doublebandingiscriticaltogeneratemaximumradialcompressionofbandingtopole
andMountingBracket.
5 Followsp
ecificmanufacturer'sinstructionsfortensioningbandstorecommendedlevels.
6 Rolltoo
lover,bendingbandoveritselfatexitfromthebuckle,asshownabove,orasinstructedinthe
manufacturer'sinstructionstotemporarilysecuretensionedband.
7 Cutbandusin
gtensioningtoolasinstructedinthemanufacturer'sinstructions.