User's Manual
Table Of Contents
- Preface
- Overview of RF Modules for Prism Remote Units
- Install the RF Module(s)
- Safety Precautions
- Guard Against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
MOD A
MOD D
MOD C
MOD B
SeRF
Module
TX0/RX0
RX1
DIV
PRIM
PWR
Note routing of
high-speed cables
Note bend
radii ≥ 1-inch
Edge of Connector Interface Panel
Cable connections for a Single-Slot RF Module
Install the RF Module(s)
Page 38 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
Figure21.Cable Connections for Single-Slot RF Modules