User's Manual

Table Of Contents

Connect the RF Module Cables

FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 37

13 Workingfromthebottomconnectorup,connecttheRFModulecables.

a IfthisisaDiversitychassis:

• ForSingle‐Slotinstallationsonly—connecttheRFDiversitycablelabeledMODN

TX1/RX1

totheTX1/RX1connectorandturnthethumbscrewtosecurethecabletothe

chassis.

• ForDual‐Slotinstallationsonly—theTX1/RX1connectorispre‐populated.Donot

removethefactoryconnectiontoRX1.Instead,securethe

MODNTX1/RX1cabletothe

cablebundleusingoneoftheprovidedcableties.Ensurethatthe

MODNTX1/ RX1cable

andconnectoraresecuredsotheywillnotbepinchedorpreventthedoorfrom

closing.

b ConnecttheRFcablelabeledMODNTX0/RX0totheTX0/RX0connectorandturnthe

thumbscrewtosecurethecabletothechassis.

c ForSingle‐Slotinstallationsonly—connecttheMODNDIV LVDScabletotheDIV

connector.ThisconnectstheRemoteUnitSeRF(RSI)interfaceboardtotheDiversity

DART.MakesurethatyouheartheLVDScablelockintotheDIVconnectorwithanaudible

click.GiveagentletugontheLVDScable—ifyoudonotpresstheunlocklever,theLVDS

cableshouldnotcomeoutoftheconnector.

NOTE: AlwaysconnecttheDiversityLVDScable.Thispreventsthecablefromgettingcaughtbetween

thechassisdoorandtheRFModule.

d ConnecttheMODNPRIMLVDScabletothePRIMconnector.ThisconnectstheRSItothe

PrimaryDART.

e ConnectthePowercabletothePWRconnector.ThisconnectstheRFModuletotheDC

powerconnection.

f ForDual‐Slotinstallationsonly—thePower(PWR)cableandtwoLVDScablesofthe

upperRFModuleshelfarenotbeused.ConnecttheRFcablelabeled

MODN TX1/RX1ofthe

upperRFModuleshelftotheconnectorlabeled

N/ContheupperhalfoftheDual‐Slot

module.Useoneoftheprovidedcabletiestosecurethe

MODNTX0/RX0RFcable,both

LVDScablesandthePower(PWR)cabletotheRFcablelabeled

MODNTX1/RX1,ensuring

thatthecablebundlewillnotbepinchedorpreventthePRUdoorfromclosing.

RefertothegraphicthatcorrespondstotheRFModulebeinginstalled:

• Single‐SlotRFModule:Figure21onPage38

• HDMRFModule:Figure22onpage39

• Dual‐BandDual‐SlotRFModule:Figure23onPage40

• Dual‐Slot40WRFModule:Figure24onPage41.