User's Manual

Install the RF Module(s)
Page 30 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
8 PushtheleftedgeoftheRFModulebackandintothePRUchassisuntilitcangonofurther,as
showninthefollowinggraphics:
• ForSingle‐SlotRFmodules,seeFigure15onpage30.
• ForHDMRFmodules,seeFigure16onpage31.
• ForDual‐SlotRFmodules,seeFigure17onpage32,whichusestheDual‐Slot40WRF
Moduleasanexample.
CAUTION! MakesuretheRFModuleisseatedcorrectlyintheModuleshelf.IncorrectalignmentoftheRF
ModulecancausetheRFModuletofailduetooverheating.
•Thefronted
geoftheRFModuleshouldbeparallelwiththeshelfaboveit.
•TheMo
untingHookontheRFModuleshouldbefullyengagedwiththeReceivingflangeon
thePRUchassis.
•Ifyoulatercannotsh
utthePRUdoor,verifythattheRFModuleisinstalledcorrectly.
Push the RF Module
back into the chassis
until it can go no further.
Single-Slot
RF Module
Figure15.Seating a Single-Slot RF Module