User's Manual

Install the RF Module(s)
Page 22 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
ForHDMRFModules,thethermalpadsarelocatedaslistedbelowandasshowninFigure10.
• onepadforeachRxandTxboard
• onelargepadovertheDPM
• oneforeachPowerAmplifier(PA),whichisonthebottomoftheHDMRFModule.
DPM Thermal Pad
Tx A Thermal Pad
Tx B Thermal Pad
Rx A Thermal Pad
Rx B Thermal Pad
2.9796 in2.9796 in
NOTE: Tx and Rx cards are paired: Tx A ony pairs with Rx A and Tx B only pairs with Rx B.
Figure10.Thermal Pads on an HDM RF Module