User's Manual

PRU RF Module Types
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 17
TECP-77-141 • Issue 1 • April 2012 © 2012 TE Connectivity Ltd.
PrismRemoteUnitHDMRFModules
PRUHDMRFModules(Figure7)aredesignedfor850Cellfrequencies.Theinitialreleaseofthe
HDMRFModuleisaSingleInputSingleOutput(SISO)Configurationthat
• interfacesoneHostDART—eitherClassicorSuperDART
• supportstwonon‐contiguousRFslicesupto25MHztotalbandwidth—SuperDARTonly
• supportsupto40WRFoutputpower.
Figure7.HDM RF Module
ThecomponentsofaPRUHDMRFModuleisdependentonthemoduletype,aslistedinTable9.
Table9. ComponentsofPRUHDMRFModules
RF Module Type DPM LPA Duplexer Rx Card Tx Card
SISO 1 1 1 1 1
Diversity* 1 1 2 2 1
MIMO* 1 2 2 2 2
* Not supported in this
release.