User's Manual
Table Of Contents
- Preface
- Overview of RF Modules for Prism Remote Units
- Install the RF Module(s)
- Safety Precautions
- Guard Against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Overview of RF Modules for Prism Remote Units
Page 14 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
Table 8 lists how the FlexWave Prism EMS references the RF group assignments
and corresponding components of each RF Module.
Table 8.
Remote Unit RF Group Assignments (from Top/Down)
Physical
RF Slot
RF
Group
DART
Number
LNA Number
LPA
Number
for Single
LPA
LPA
Number
for Dual
LPAs
Power
Detector
Number
for Single
PD
Power
Detector
Number
for Dual
PDs
Primary Diversity
D D
8 8
7
8
7
8
7 7 7 7
C C
6 6
5
6
5
6
5 5 5 5
B B
4 4
3
4
3
4
3 3 3 3
A A
2 2
1
2
1
2
1 1 1 1
SeRF Board
NOTE: In a dual-LPA system, the Configure Remote Forward Gain page shows two values for the LPA
status, one for each LPA. Changing the LPA Mode or resetting the LPA applies to both LPAs at the
same time.
CAUTION! Should your system experience an LPA problem, refer to Table 8 to ensure that you apply new
settings or troubleshoot the correct RF Module.
CAUTION! If you use a customized SNMP polling for system status, you must change your LPA indexing
scheme.