User's Manual
Table Of Contents
- Preface
- Overview of RF Modules for Prism Remote Units
- Install the RF Module(s)
- Safety Precautions
- Guard Against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Table5. LPAMaximumCompositeTxPowerLevelsforDual‐Slot40WRFModules
Passband Maximum
dBm
Watts Instantaneous
Bandwidth (MHz)
PCS 1900 +46 40 70
AWS 2100 +46 40 45
Overview of RF Modules for Prism Remote Units
Page 10 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
DigitalProcessingModule
TheDigitalProcessingModule(DPM)isfoundonlyintheHDMRFModules.TheDPMprovides
theprimaryprocessingandlogicfunctionsfortheHDMRFModule.Italsoprovidestheprimary
powerinterfacefortheHDMRFModule,andconversionofthenative28VDCvoltagetolower
voltagesasnecessaryforfunctionality.
TheDPMhasaTransmit(Tx)BoardandaReceive(Rx)Board:
• TxBoard—providesbandspecificfilteringfortheintendedTransmitpath.
• RxBoard—providesbandspecificfilteringfortheintendedReceivepath.
RFModuleCables
TheRFModulecablesthatarepre‐installedinthePRUconnecttothecorrespondingconnectors
ontheRFModule.TheRFModulecablescorrelatetotheantennaconnectorsonthebottomofthe
PRUchassis.
RFModuleCablesforSingle‐Card,Dua
l‐Card,andHDMRFModules
TheRFcableandconnectorlabelsalsocorrespondtotheRFModul
eslotsinthePRUchassis,
where
MODAisthebottomslotandMODDisthetopslot.Intheinstallationsteps,theRFcables
andconnectorsarereferredtoas
MODNTX0/RX0andasMODNTRX1whereNequalsA,B,C,orD.
Thecablesandconnectorshavecorrespon
dinglabelsasshowninTable6forSingle‐Card,
Dual‐Card,andHDMRFModules.