User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Table5. Dual‐BaySuperDARTs
DARTModuleType Maximum
Bandwidth
(MHz)
Numberof
FiberSl
ots
1800GSMDLSuperDART 75 12
1900PCSDLSup
erDART 70 12
2100AW
SDLSuperDART 45 8
2100UMTSDLSup
erDART 60 12
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page7
TECP‐77‐141Issue6 • 300001744178RevF • April2014 ©2014 TEConnectivityLtd.
RFModuleTypes
ThePRURFModulesareavailableinthefollowingformats,andasdescribedinthefollowingsections:
• “Single‐andDual‐BayRFModuleswithClassicorSuperDARTs”onpage7
• “HDMRFModules”onpage8
• “LegacyDual‐Bay40WRFModules”onpage9.
Single‐andDual‐BayRFModuleswithClassicorSuperDARTs
Figure2showsexamplesof
Single‐andDual‐BayRFModules,
both
ofwhichhavetwoDARTs.
Single‐BayRFModuleshavethe
fo
llowingelements:
• oneortwoDARTs
• oneDuplexer
• oneLinearPowerAmpli
fier
(LPA)
• one
RemoteDARTInterface
(RDI)board.
Dual‐BandDual‐BayRFModules
havethefollowingelements:
• twoDARTs
• twoDuplexers
• oneLinearPowerAmpli
fier
(LPA)
• one
RemoteDARTInterface
(RDI)board.
Dual-Band Dual-Bay RF Module
Single-Bay Dual-Card RF Module
Figure2.Single‐andDual‐BayRFModules