User's Manual

Cable Connections for an HDM RF Module
TX0/RX0
TX1/RX1
POWER
DATA 1 (DIV)
DATA 0 (PRIM)
Cable Connection Notes
• Always connect the Power cable.
• Always connect the two LVDS cables: PRIM and DIV.
• SISO requires one RF cable (TX1/RX1).
• MIMO and Dual-Band require two RF cables
(TX1/RX1 and TX0/RX0).
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page35
TECP‐77‐141Issue6 • 300001744178RevF • April2014 ©2014 TEConnectivityLtd.
Figure22.CableConnectionsforHDMRFModules
ConnectingCablesinaDual‐BayRFModuleInstallation
1 PositionthecablessothattheyareundertherightedgeoftheRFModule,pointingup.
2 Fol
lowtheruleslistedin“UnderstandingtheRFModuleCables”onpage12.
3 Fol
lowtheruleslistedbelowthatpertainonlytoDual‐BayRFModules.
• T
heupperRFModuleshelfwilleithernotbepresent(factoryinstalledmodule)orwillberemovedprior
toinstallation(fieldinstalledmodule).
• The
MODNTX0/RX0cableforthelowerRFModulebaywillneedtobeconnectedtotheMODNTX0/RX0
N‐StyleRFconnectionoftheDual‐BayRFModule.
• ConstraintheMOD
NTX1/RX1cabletotheexistingcablesusingatiewrapsuchsoitcannotbepinched
orpreventthePRUdoorfromclosing.DonotcutorattempttootherwiseremovethisRFcable.
• TheRFcab
lesandtwoLVDScablesofthelowerRFModulebayarenotusedwheninstallingaDual‐Bay
RFModule.
• Table12listshowtocorrectlyconnectHDMRFModulestotheAntennaportsonthebottom
ofthePRU.
Table12.
HDMAntennaPortMapping
RFModuleCatalog# Description
TX0/RX0 TX1/RX
1
HDMDUAL20
W850/1900RFMODULE 1900 850
HDMDUAL20
W,700ABC/700UC,RFMODULE 700lABC 700uC
HDMMIMO20W700LOWERAB
CRFMODULE Path1 Path2
HDMMIMO20W700U
PPERCMODULE Path1 Path2
HDMMIMO20W2100AWSRFMODULE Path1 Path2
HDMMIMO20W1900PCSRFMOD
ULE Path1 Path2
FWP‐ C
4MT000MOD
FWP‐ L4
MTU4MMOD
FWP‐ L4
MT000MOD
FWP‐ U4MT000MOD
FWP‐ A
4MT000MOD
FWP‐ 84MT0
00MOD