User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page32 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014 TEConnectivityLtd. TECP‐77‐141Issue6 • 300001744178RevF • April2014
LatchesonLegacyDual‐Bay40WRFModules
ForLegacyDual‐Bay40WRFModules,securefourlatches,asshowninFigure20.
Four latches in a
Legacy Dual-Slot 40W
RF Module
Figure20.LegacyDual‐Bay40WRFModuleLatches
VerifythattheRFModuleMountingHookisEngaged
1 VerifythattheRFModuleMountingHookisengagedcorrectlybypullingthemoduleawayfromtheheatsink.
TheRFModuleshouldnotmove.IftheRFModulemovesduringthischeck,repeatallthestepsstartingat
“InstalltheRFModuleintothePrismRemoteChassis”onpage22throughthisstep.
ConnecttheRFModuleCables
ThestepstoconnecttheRFModulecableshavebeenseparatedintotwodifferentprocedures;followthesteps
thatcorrespondtotheRFModulebeinginstalled.
• “ConnectingCablesinaSingle‐BayRF
ModuleInstallation”onpage33
• “Conn
ectingCablesinaDual‐BayRFModuleInstallation”onpage35.